IMPORTANT: You must have current, properly marked swaging equipment to buy bulk hose or hose ends. Refer to "HYDRAULIC HOSE/FITTINGS/SWAGING GUIDE" for information concerning swaging equipment and proper swaging procedures.

HOW TO ORDER HOSE ASSEMBLIES

First, identify hose diameter. Use the print on the hose cover. The following are the designations for different hose diameters:

~ 02 – 1/8 inch
~ 03 – 3/16 inch
~ 04 – 1/4 inch
~ 05 – 5/16 inch

Note: Hose designations are for the inside diameter of the hose. Print on some hose will indicate the fractional inside diameter of the hose such as 1/8 or 3/16.

Next, determine the assembly length needed by measuring end of fitting to end of fitting of the existing hose assembly. Replacement assemblies are available in 6 inch increments up to 15 feet and 1 foot increments up to 40 feet. If the existing assembly is in between available lengths, choose the next longest assembly available.

In the chart below, the replacement part number for hose assemblies are listed by length under each hose diameter.

Note:
~ For 1/4 inch hoses with 5/16 inch hose ends, use a 5/16 inch replacement hose.
~ For hoses with a male hose end, use a standard replacement hose and order a RF2539 union for 1/8, 3/16 and 1/4 inch hoses.

Hose assemblies presently produced by HWH Corporation, will have a part tag at both ends of the hose assembly next to the hose end. The tag will have an AP part number, the length and diameter of the assembly. Older hose assemblies or hoses that have been repaired may not have a part tag. Although the tag information can be used to determine the replacement hose needed, it is the customer’s responsibility to determine the proper size and length of hose assembly needed for repair.

A few longer assemblies are available in 04 and 05 hose.